ProcessMaster FEP610, HygienicMaster FEH610 | OI/FEP610/FEH610-EN Rev. B 77
11 Recycling and disposal
11.1 Dismounting
WARNING
Risk of injury due to process conditions.
The process conditions, e.g. high pressures and
temperatures, toxic and aggressive measuring media, can
give rise to hazards when dismantling the device.
— If necessary, wear suitable personal protective
equipment during disassembly.
— Before disassembly, ensure that the process conditions
do not pose any safety risks.
— Depressurize and empty the device / piping, allow to
cool and purge if necessary.
Bear the following points in mind when dismounting the
device:
— Switch off the power supply.
— Disconnect electrical connections.
— Allow the device / piping to cool and depressurize and
empty. Collect any escaping medium and dispose of it in
accordance with environmental guidelines.
— Use appropriate tools to dismount the device, taking the
weight of the device into consideration.
— If the device is to be used at another location, the device
should preferably be packaged in its original packing so
that it cannot be damaged.
— See the information in chapter "Returning devices" on
page 76.
11.2 Disposal
This product and its packaging are manufactured from
materials that can be recycled by specialist recycling
companies.
Bear the following points in mind when disposing of them:
— This product is not subject to WEEE Directive 2002/96/EC
or relevant national laws (e.g. ElektroG in Germany).
— The product must be surrendered to a specialist recycling
company. Do not use municipal garbage collection points.
According to WEEE Directive 2002/96/EC, only products
used in private applications may be disposed of at
municipal garbage collection points.
— If it is not possible to dispose of old equipment properly,
ABB Service can take receipt of and dispose of returns for
a fee.
NOTE
Products that are marked with this symbol may
not be disposed of through municipal garbage
collection points.
11.3 Information on ROHS Directive 2011/65/EC
The products provided by ABB Automation Products GmbH
do not fall within the current scope of regulations on
hazardous substances with restricted uses or the directive on
waste electrical and electronic equipment according to
ElektroG.
If the necessary components are available on the market at
the right time, in the future these substances will no longer be
used in new product development.
To Next Page
Loading...
