ProcessMaster FEP610, HygienicMaster FEH610 | OI/FEP610/FEH610-EN Rev. B 63
Menu / parameter Description
Diagnostics / ......Simulation Mode
Simulation Switch Manual simulation of measured values. After selecting the value to be simulated, a corresponding parameter is
displayed in the menu "Diagnostics / ......Simulation Mode". The simulation value can be set here.
The output values correspond to the simulated measured value entered.
The "Configuration" information is displayed in the lower line of the display.
Only one measured value / output can be selected for simulation.
After power-up / restart of the device, the simulation is switched off.
Off
Qm Massflow [unit]
Qm Massflow [%]
Qv Volumeflow [unit]
Qv Volumeflow [%]
Curr.Out 31 / 32
Dig.Out 41 / 42 State
Dig.Out 41 / 42 Pulse
Dig.Out 41 / 42 Freq.
Dig.Out 51 / 52 State
Dig.Out 51 / 52 Pulse
Diagnostics / ...Output Readings
Curr.Out 31 / 32 Display the current values and statuses of the listed inputs and outputs.
Dig.Out 41 / 42 Freq.
Dig.Out 41 / 42 State
Dig.Out 51 / 52 State
7.5.9 Menu: Totalizer
Menu / parameter Description
Totalizer
...Reset Totalizer Selection of submenu "...Reset Totalizer" using .
...Preset Totalizer Selection of submenu "...Preset Totalizer" using .
Totalizer / ...Reset Totalizer
All Totalizer Resets all totalizers to zero.
Massflow Fwd Resets individual counters.
Massflow Rev
Volumeflow Fwd
Volumeflow Rev
Totalizer / ...Preset Totalizer
Massflow Fwd Allows to edit/preset the totalizer values (e.g. when replacing the transmitter).
Massflow Rev
Volumeflow Fwd
Volumeflow Rev
7.6 Software history
In accordance with NAMUR recommendation NE53, ABB offers a transparent and traceable software history.
Device software package FEx610 (Device Firmware Package)
Version Issue date Type of change Description Order number
00.01.04 04.2016 First release — 3KXF002044U0100_00.01.04
Change from one to tw o columns