4.
To browse different function blocks, scroll the list with and and to select a
function block press . To move back to the list, press .
The function block list is shown in the content area of the display. On the left in the
header, you see the current setting group, and on the right the menu path.
5.
To browse the parameters, scroll the list with and and to select a parameter,
press .
The setting group values are indicated with #.
A070899-ANSI V2 EN
Figure 76: Setting group parameter
6.
To select a setting group value, press
and to edit the value press .
A071168-ANSI V2 EN
Figure 77: Selecting the setting group value
Only values within the selected setting group can be changed.
7.
Press or to change the value and to confirm the selection.
1MAC054853-MB B Section 6
Operating procedures
615 series ANSI 105
Operation Manual
To Next Page
Loading...
