A070860-ANSI V2 EN
Figure 27: Clear view
2.
Select the item to be cleared with or .
3.
Press
, change the value with or and press again.
The item is now cleared.
4. Repeat steps 2 and 3 to clear other items.
Use the button as a shortcut for clearing. The first three-second press
clears the indications. The second three-second press clears the
programmable LEDs.
4.1.15 Using the local HMI help
1.
Press
to open the help view.
2.
Scroll the text with or if the help text exceeds the display area.
3.
To close the help, press
.
4.2 Using the Web HMI
WHMI is disabled by default, and has to be activated in the protection relay configuration.
As secure communication is enabled by default, the WHMI must be accessed from a Web
browser using the HTTPS protocol.
Section 4 1MAC054853-MB B
Using the HMI
54 615 series ANSI
Operation Manual
To Next Page
Loading...
