1. To enable the WHMI, select Main menu/Configuration/HMI/Web HMI mode
via the LHMI.
2. Reboot the relay for the change to take effect.
3. Log in with the proper user rights to use the WHMI.
To establish a remote WHMI connection to the protection relay, contact
the network administrator to check the company rules for IP and remote
connections.
Disable the Web browser proxy settings or make an exception to the proxy
rules to allow the protection relay's WHMI connection, for example, by
including the relay's IP address in Internet Options/Connections/LAN
Settings/Advanced/Exceptions.
4.2.1 Logging in
1. Type the username with capital letters.
2. Type the password.
GUID-319BE86A-1B2B-4BD8-8061-A8D968B1A3AD V1 EN
Figure 28: Entering username and password to use the WHMI
3. Click OK.
The language file starts loading and the progress bar is displayed.
4.2.2 Logging out
The user is logged out after session timeout. The timeout can be set in Main menu/
Configuration/HMI/Web HMI timeout.
• To log out manually, click Logout on the menu bar.
1MAC054853-MB B Section 4
Using the HMI
615 series ANSI 55
Operation Manual
To Next Page
Loading...
