For parameters with defined steps, digits smaller than the step value
cannot be edited.
3.
Press or to move the cursor to another digit.
4. To select the minimum or maximum value, select the arrow symbol in front of the
value.
•
To set the value to the maximum, press
.
•
To set the value to the minimum, press .
A070756 V3 EN
Figure 24: Arrow symbol is active, the value is set to the maximum
After pressing , the previous value can be restored by pressing once, and vice
versa. Another press of or sets the value to the lower or higher limit. The
symbol in front of the value is ↕, when the previous value is shown.
A070757 V3 EN
Figure 25: Restoring the previous value
1MAC054853-MB B Section 4
Using the HMI
615 series ANSI 51
Operation Manual
To Next Page
Loading...
