A070931-ANSI V2 EN
Figure 41: Writing values to protection relay
The values are not stored to the flash memory.
2. Click Commit to write the values to the flash memory.
• Click Reject to cancel saving settings.
• If the parameter has an edit-copy, the original parameter value is
restored.
• If the parameter does not have an edit-copy, the edited parameter value
remains visible until the protection relay is rebooted. However, the
edited value is not stored in the nonvolatile memory and thus the reboot
restores the original value.
Section 4 1MAC054853-MB B
Using the HMI
66 615 series ANSI
Operation Manual
To Next Page
Loading...
