ABB ret650 - Signals; Operation Principle; GOOSE Function Block to Receive a Double Point Value GOOSEDPRCV; Identification

16.6.4 Signals
Table 452: GOOSEVCTRRCV Input signals
Name
Type Default Description
BLOCK BOOLEAN 0 Block function
Table 453: GOOSEVCTRRCV Output signals
Name Type Description
VCTR_RCV GROUP SIGNAL Output group connection to voltage control
DATAVALID BOOLEAN Data valid for output signals
COMMVALID BOOLEAN Communication valid for output signals
TEST BOOLEAN Test output
16.6.5 Operation principle
The DATAVALID output will be HIGH if the incoming message is with valid data.
The COMMVALID output will become LOW when the sending IED is under total
failure condition and the GOOSE transmission from the sending IED does not happen.
The TEST output will go HIGH if the sending IED is in test mode.
The input of this GOOSE block must be linked in SMT by means of
a cross to receive the voltage control values.
The implementation for IEC61850 quality data handling is restricted
to a simple level. If quality data validity is GOOD then the
DATAVALID output will be HIGH. If quality data validity is
INVALID, QUESTIONABLE, OVERFLOW, FAILURE or OLD
DATA then the DATAVALID output will be LOW.
16.7 GOOSE function block to receive a double point
value GOOSEDPRCV
16.7.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
GOOSE function block to receive a
double point value
GOOSEDPRCV - -
1MRK 504 135-UEN A Section 16
Station communication
543
Technical manual