ABB ret650 - Functionality; Function Block; Signals; Settings

16.7.2 Functionality
GOOSEDPRCV is used to receive a double point value using IEC61850 protocol via
GOOSE.
16.7.3 Function block
IEC10000249-1-en.vsd
GOOSEDPRCV
BLOCK ^DPOUT
DATAVALID
COMMVALID
TEST
IEC10000249 V1 EN
Figure 242: GOOSEDPRCV function block
16.7.4 Signals
Table 454: GOOSEDPRCV Input signals
Name Type Default Description
BLOCK BOOLEAN 0 Block of function
Table 455: GOOSEDPRCV Output signals
Name
Type Description
DPOUT INTEGER Double point output
DATAVALID BOOLEAN Data valid for double point output
COMMVALID BOOLEAN Communication valid for double point output
TEST BOOLEAN Test output
16.7.5 Settings
Table 456: GOOSEDPRCV Non group settings (basic)
Name
Values (Range) Unit Step Default Description
Operation Off
On
- - Off Operation Off/On
16.7.6 Operation principle
The DATAVALID output will be HIGH if the incoming message is with valid data.
The COMMVALID output will become LOW when the sending IED is under total
failure condition and the GOOSE transmission from the sending IED does not happen.
The TEST output will go HIGH if the sending IED is in test mode.
Section 16 1MRK 504 135-UEN A
Station communication
544
Technical manual