- 143 -
UMC22-FBPFieldBusPlug / Issue: 02.2008
V 6
Universal Motor Controller UMC22-FBP
Software version 4.0
Chapter 8.2.1~4
Par.
No.
Menu
No.
Menu point name Display:
7-segm.
Default Range Description / remark take over
- 1.3.17
PTC temperature
Motor temperature to high -
1.3.18
PTC wire break
One of the PTC feed lines is broken
1.3.19
PTC short-circuit
1.3.20
Earth fault
1.3.21
Address fault
Address check monitors: addresses of
FieldBusPlug and UMC22 are different
1.3.22
Fault on DI0
External fault signaled via DI0
1.3.23
Fault on DI1
External fault signaled via DI1
1.3.24
Fault on DI2
External fault signaled via DI2
- 1.4
Digital input,
digital output
-
1.4.0 DI0
Example: 0 signal at digital input 0
: DI1...DI5...DO0..
DO1
::
1.4.8 DO 2
Example: 1 signal at digital output 2
1.4.9 Status DI, DO
Left place of the display:
"d" for digital I/O
Upper vertical lines of the 2 right
places:
Signal status of the 3 digital outputs,
from DO0 (right) to DO2 (left).
Line visible = 1.
Lower vertical lines of the 3 right
places:
Signal status of the 6 digital inputs,
from DI0 (right) to DI5 (left).
Line visible = 1.
Horizontal lines: Shall help to fi nd I/O
number.
Example shown left:
DO-Nr. : 0,1,2
DO-Status: 1 0 1
DI-Status: 1 1 1 0 1 0
DI-Nr. : 0,1,2,3,4,5
To Next Page
Loading...
