CHAPTER 13. ROUTING AND I/O 174
Tap Points for Track
Routing.
Pre FX taps the signal that is coming directly from a track, before it has been passed
on to the track's device chains (FX) or mixer. Therefore, changes that are made to the
tapped track's devices or mixer have no effect on the tapped signal. Soloing a track
that taps another track Pre FX will allow you to hear the tapped track.
Post FX taps the signal at the output of a track's device chains (FX), but before it
has been passed back to the track mixer. Changes to the tapped track's devices will
therefore alter the tapped signal, but changes to its mixer settings will not. Soloing a
track that taps another track Post FX will allow you to hear the tapped track.
Post Mixer taps the nal output of a track, after it has passed through its device chains
and mixer. Soloing a track that taps another track Post Mixer will not allow you to hear
the tapped track.
To Next Page
Loading...