Accu-Chek ACTIVE User Manual

70
Checking your meter
Checking your meter7
You can check whether the meter provides correct
results. To perform this performance check, a glucose
control solution is applied to the test strip instead of
blood.
Also read the instrcutions in Chapter 5.
Perform a performance check using Accu-Chek
Active control solutions,
whenever you open a new pack of test strips,

after you change the battery,

after you clean the test strip guide and the meas-

uring window,
if you are in doubt about a test result.

Please ask your customer support and service centre
where you can obtain the control solutions.

Accu-Chek ACTIVE Specifications

General

Measurement Range	10-600 mg/dL
Sample Size	1 - 2 μL
Test Time	5 seconds
Memory Capacity	500 results
Display Type	LCD
Automatic Coding	Yes
Blood Sample	Capillary whole blood
Dimensions	97.8 x 46.8 x 19.1 mm
Battery Type	1 x 3V lithium battery (type CR2032)
Battery Life	Approximately 1000 tests
Data Transfer	Via infrared (IR) to computer
Operating Conditions	8-42°C, 10-85% RH