8
Probe information
Your accumet AP75 meter uses a conductivity/
TDS cell with a sturdy 6-pin connector. This cell
is designed for use with accumet waterproof
meters only.
Your meter includes an Ultem/Stainless Steel
cell with a cell constant of K = 1.0. This
conductivity/TDS cell features a built-in tem-
perature sensor for Automatic Temperature
Compensation (ATC). It has a specially
designed housing that provides fast tempera-
ture response and reduces air bubble entrap-
ment, which makes it easy to obtain accurate,
stable readings.
Wetted parts include:
1. Polyetherimide (Ultem)
2. Polybutylterphalate (Valox)
3. Stainless steel (SS 304)
NOTE: We recommend that the you do not sub-
merse the probe above the protective yellow
cap. You can submerse the cable for brief peri-
ods of time, but not continuously.
See section 8 on page 41 for probe care and
maintenance information.
3.2
To Next Page
Loading...
