Acea RTCA SP Instrument - Page 34

34
RTCA SP Instrument Operator’s Manual
B
B
Installation
Resistor Plate Verifi cation of RTCA SP Instrument

If the acceptance criteria described in 5. and 6. are fulfi lled, the resistor plate verifi cation
is passed successfully. If the criteria are not fulfi lled, please contact your local ACEA
representative.
Remove the RTCA Resistor Plate 96

To remove the RTCA Resistor Plate 96 from the RTCA SP Station, press down lightly
on the clamp plate. Then lift the lock handle gently to release, slowly allowing the lock
handle to rotate upwards. Now lift the clamp plate and take the RTCA Resistor Plate
96 out (Figure 21).
Figure 21: Removal of an RTCA Resistor Plate 96 from the RTCA SP Station.

34
RTCA SP Instrument Operator’s Manual
B
B
B
B
B
B
B
B
B
Installation
Resistor Plate Verifi cation of RTCA SP Instrument

If the acceptance criteria described in 5. and 6. are fulfi lled, the resistor plate verifi cation
is passed successfully. If the criteria are not fulfi lled, please contact your local ACEA
representative.
Remove the RTCA Resistor Plate 96

To remove the RTCA Resistor Plate 96 from the RTCA SP Station, press down lightly
on the clamp plate. Then lift the lock handle gently to release, slowly allowing the lock
handle to rotate upwards. Now lift the clamp plate and take the RTCA Resistor Plate
96 out (Figure 21).
Figure 21: Removal of an RTCA Resistor Plate 96 from the RTCA SP Station.
