Acer P5271 - Chapter 4 Function Test & Alignment Procedure; Test Equipment Needed; Introduction of LAN Cable(Only for P5271 I); Service Mode

P5271/P5290/P5390W/P5271i
Condential
4-1
Chapter 4
Function Test & Alignment Procedure
4-1 Test Equipment Needed
- IBM PC with SVGA/XGA resolution
- DVD player with Multi-system, equipped "Component", "S-Video","Composite" and
"HDMI".
- HDTV Source (480P, 720P, 1080i, 1080P)
- Minolta CL-100
- Quantum Data 802B or CHROMA2327 (Color Video Signal & Pattern Generator)
4-2 Introduction of LAN Cable(only for P5271i)
If you use P5271i network function, you have to
use the special LAN cable with one end adopts special
connection method: the wires of Pin 2 and Pin 6 are
exchanged.(the order of Pin1 to Pin8 is as right picture)
4-3 Service Mode
1. Turn on the projector
2. Do the following actions sequentially to get into Service Mode
(1) Press "Power", "Left", "Left" and "Menu" buttons sequentially.
(2) Service Mode will be shown.
(3) Choose "Exit" to leave the Service Mode after conrming the conguration.
4-4 OSD Reset
1. After nal QC step, we have to erase all saved change again and restore the OSD
default setting. The following actions will allow you to erase all end-users' settings and
restore the default setting:
Pin1
Pin8
----->