- Plug in power cord.
- Hold on the "Up" button, then press the "Power"
button, the Power LED lights blue.
- Wait a moment, the Temp LED ashes red.
- After several seconds, the Lamp LED and Temp LED
light red.
- Loosen the "Up" button.
- After that, the projector will automatically get into
standby status.
- Waveform Download is completed.
Note: - This step must be executed after Lamp Driver
changed.
5-1-7 Restore Blower Speed
- Plug in power cord.
- Hold on the "Left" button, then press the "Power"
button.
- After about 2 seconds, the Power LED lights purple ,
the Lamp LED and Temp LED light red.
- The projector will be on and the message appears as
the right picture shows.
- After about 70 seconds, the Lamp LED and Temp LED
will be off, the Power LED will light blue.
To Next Page
Loading...
