Acom eBox - Page 21

User's Manual | ACOM eBox | Ethernet Remote Control Device
October 2021
S e c t i o n POWER ON AND INDICATORS | Page
21
of
60
• LOCAL indicator
Lights on: The ACOM amplifier is being controlled via local RCU;
Lights off: The ACOM amplifier is NOT controlled via local RCU;
• OPER indicator
Lights on: The ACOM amplifier is in OPERATE mode;
Lights off: The ACOM amplifier is NOT in OPERATE mode;
• STDBY indicator
Lights on: The ACOM amplifier is in STANDBY mode;
The input RF signal passes directly to the RF output of the
amplifier, bypassing the amplification stage;
Lights off: The ACOM amplifier is NOT in STANDBY mode.
The meanings of two small (rectangular) LED indicators under the LAN socket (see Figure 3-1 Front panel -
Connection and indicators with power on, Pos. (2)) are as follow:
• LAN left indicator
Lights on: Ethernet/LAN connection is operating;
Lights off: The device is NOT connected to the LAN network;
• LAN right indicator
Lights blinking: There is activity on this LAN port;
Lights off: No datalink is established.