15
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
SETUP - Channel Selection
Select which nodes to add as channels.‘SoL’ marks nodes that are
yet to be configured and‘TX’ denotes available transmitters.
#Name
AdderLink XDIP 02DF3B
Description
Description
Description
NEXTBACK
SoL
Transmitter 1
TX
You will now see a list of all discovered nodes. If an entry shows SoL (Start of Life)
then it is uncongured (that node’s PWR indicator will also show red). Otherwise, any
discovered transmitter node, that is already congured, will show TX:
INITIAL CONFIGURATION (continued)
Notes
• If you are adding several nodes at once and need to identify a particular node, click the
icontoashthefrontpanelindicatorsofthechosennodeinthelist.
• If nodes have been added since displaying the list, click the icon to refresh the list.
9 Click an entry marked SoL to congure it as a transmitter:
SETUP - Basic Information
Enter the name,description, and admin and access password for
this transmitter.
Transmitter Name
Transmitter Description
New Admin Password
NewAccess Password
Confirm Admin Password
Confirm Access Password
Description
Password for Node Configuration
Password for User Access
Password for Node Configuration
Password for User Access
Transmitter 2
Cancel OK
10 Enter the details for this transmitter, including two separate passwords:
• The Admin Password is required to administer the conguration details only,
• The Access Password allows you to restrict who is allowed to connect to this
transmitter. When the Access Password is set, a user will be prompted to enter
it when rst attempting to add this transmitter node to their receiver node’s
channels list; if the Access Password is left blank, there will be no access restrictions.
Note:TheNameandDescriptioneldsforeachentrycannotbeleftblank.
11 Click OK. The discovered nodes will be again listed, showing any changes you have
made to the name(s) and description(s):
SETUP - Channel Selection
Select which nodes to add as channels.‘SoL’ marks nodes that are
yet to be configured and ‘TX’ denotes available transmitters.
#Name
Transmitter 1
Description
Description
NEXTBACK
1
Transmitter 2Description
TX
continued
12 Repeat steps 9 to 11 for each listed SoL node.
13 Ensure that all the transmitters (8 maximum), to which you wish to connect from this
receiver, show a number in the left hand column. If an entry shows TX, it is yet to be
connected. Click on the entry to connect it with this receiver; if an access password
is set on the transmitter, you will be asked to enter it. Once successfully connected,
the TX for the entry will change to a number.
14 When all transmitters have been connected, click NEXT.
To Next Page
Loading...
Need help?
General
