ADLINK Technology PCI-8102 - Page 101

MotionCreatorPro 91
1. ALM Logic and Response mode: Select logic and
response modes of ALM signal. The related function call
is _8102_set_alm().
2. INP Logic and Enable/Disable selection: Select logic,
and Enable/ Disable the INP signal. The related function
call is _8102_set_inp()
3. ERC Logic and Active timing: Select the Logic and
Active timing of the ERC signal. The related function call
is _8102_set_erc().
4. EL Response mode: Select the response mode of the
EL signal. The related function call is
_8102_set_limit_logic ().
5. ORG Logic: Select the logic of the ORG signal. The
related function call is _8102_set_home_config().
6. EZ Logic: Select the logic of the EZ signal. The related
function call is _8102_set_home_config().
7. Buttons:
Z Next Card: Change operating card.
Z Next Axis: Change operating axis.
Z Save Config: Save current configuration to 8102.ini And
8102MC.ini.
Z Close: Close the menu.