124 Function Library
6.3 Initialization
@ Name
_8102_initial – Card initialization
_8102_close – Card close
_8102_get_version – Check hardware and software
version information
_8102_set_user_code – Set codes into EEPROM
_8102_get_user_code – Get codes into EEPROM
_8102_config_from_file Config – PCI-8102 setting
from file
@ Description
_8102_initial:
This function is used to initialze an 8102 card without assigning
the hardware resources. All 8102 cards must be initialized by this
function before calling other functions in your applications. By set-
ting the parameter “Manual_ID”, user can choose the type that the
card’s ID is assigned manually or automaticly.
_8102_close:
This function is used to close 8102 card and release its resources,
which should be called at the end of your applications.
_8102_get_version:
Lets users read back the firmware’s, driver’s and DLL’s version
information.
_8102_set_user_code:
Set your own codes into EEPROM. It can secure users’ appl-
caition to avoid plagiarism.
_8102_get_user_code:
Get codes that you set by the function “_8102_set_user_code”
from EEPROM.
_8102_config_from_file:
This function is used to load the configeration of the PCI-8102
according to specified file. By using Motion Creater, user could
test and configure the 8102 correctly. After saving the configura-
To Next Page
Loading...
