Connection Example 189
7 Connection Example
This chapter shows some connection examples between the PCI-
8102 and servo drivers and stepping drivers.
7.1 General Description of Wiring
Main connection between the PCI-8102 and the pulse input servo
driver or stepping driver. The following figure illustrates how to
integrate the PCI-810 2 and DIN-68M-J3A
7.2 Wiring with DIN-68M-J3A
Notice: The DIN-68M-J3A is used for wiring between Mitsubishi J3A
series servo drivers / stepper with pulse trains input driver
and ADLINK cPCI-8168, PCI-8102 motion controller card
ONLY. Never use this terminal board with any other servo
driver or cards.
To Next Page
Loading...