16 Installation
2.6 K1/K2 Pin Assignments: Simultaneous Start/
Stop
CN4 is for simultaneous start/stop signals for multiple axes or mul-
tiple cards.
Note: +5V and GND pins are provided by the PCI Bus power.
2.7 Jumper Setting for Pulse Output
J8-J11 are used to set the type of pulse output signals (DIR and
OUT). The output signal type can either be differential line driver
or open collector output. Refer to section 3.1 for detail jumper set-
tings. The default setting is differential line driver mode. The
default setting is differential line driver mode. J8 & J9 are for axis
0; J10 & J11 are for axis 1.
No. Name Function (Axis)
1 +5V PCI Bus power Output (VCC)
2 STA Simultaneous start signal input/output
3 STP Simultaneous stop signal input/output
4 GND PCI Bus power ground
To Next Page
Loading...