ADLINK Technology PCI-8102 - Page 103

MotionCreatorPro 93
1. LTC Logic: Select the logic of the LTC signal. The related
function call is _8102_set_ltc_logic().
2. LTC latch_source: Select the logic of the latch_source
signal. The related function call is
_8102_set_latch_source ().
3. SD Configuration: Configure the SD signal. The related
function call is _8102_set_sd().
4. PCS Logic: Select the logic of the SelectNo signal. The
related function call is _8102_set_pcs_logic().
5. pin23_Select Axis X: Select the configurations of the
Axis X. The related function call is
_8102_select_pin23_input.
6. pin57_Select Axis Y: Select the configurations of the
Axis Y. The related function call is
_8102_select_pin57_input.
7. Buttons:
Z Next Card: Change operating card.
Z Next Axis: Change operating axis.
Z Save Config: Save current configuration to 8102.ini And
8102MC.ini.
Z Close: Close the menu.