MotionCreatorPro 95
1. Pulse Output Mode: Select the output mode of the pulse
signal (OUT/ DIR). The related function call is
_8102_set_pls_outmode().
2. Pulse Input: Sets the configurations of the Pulse input
signal(EA/EB). The related function calls are
_8102_set_pls_iptmode(), _8102_set_feedback_src().
3. INT Factor: Select factors to initiate the event int. The
related function call is _8102_set_int_factor().
4. Buttons:
Z Next Card: Change operating card.
Z Next Axis: Change operating axis.
Z Save Config: Save current configuration to 8102.ini And
8102MC.ini.
Z Close: Close the menu.
To Next Page
Loading...
