MotionCreatorPro 99
check box “ATU” is checked, it will execute auto homing
when motion starts.
Z ERC Output: Select if the ERC signal will be sent when
home move completes.
Z EZ Count: Set the EZ count number, which is effective
on certain home return modes.
Z Mode: Select the home return mode. There are 13
modes available.
Z Home Mode figure: The figure shown explains the
actions of the individual home modes.
Z Close: Click this button close this window.
8. Position: Set the absolute position for “Absolute Mode.”
It is only effective when “Absolute Mode” is selected.
9. Distance: Set the relative distance for “Relative Mode.” It
is only effective when “Relative Mode” is selected.
10.Repeat Mode: When “On” is selected, the motion will
become repeat mode (forward<->backward or
position1<->position2). It is only effective when “Relative
Mode” or “Absolute Mode” is selected.
To Next Page
Loading...
