MotionCreatorPro 101
14.Speed_Profile: Clicking this button will show the Speed
Profile.
15.Digital I/O: Display and set Digital I/O. The related func-
tion is
_8102_get_gpio_output(),_8102_get_gpio_input(),
_8102_set_gpio_output().
16.Servo On: Set the SVON signal output status. The
related function is _8102_set_servo().
17.Play Key:
Left play button: Clicking this button will cause the 8102 start to
outlet pulses according to previous setting.
Z In “Absolute Mode,” it causes the axis to move to
position1.
Z In “Relative Mode,” it causes the axis to move forward.
Z In “Cont. Move,” it causes the axis to start to move
according to the velocity setting.
Z In “Manual Pulser Move,” it causes the axis to go into
pulse move. The speed limit is the value set by “Maxi-
mum Velocity.”
To Next Page
Loading...
