Function Library 161
GPIO INT factors
TimeOut_ms: Specifies the time-out interval, in milliseconds.
IntFactorBitNo: Specifies the bit number of the INT factor
13 When resetting the count value with a CLR signal input
14 When Latching the count value with a LTC signal input
15 When Latching the count value with an ORG signal input
16 When the SD input is ON
17 When the +/-DR input is changed
18 When the CSTA input is ON
19~31 Not define (Always set to 0)
Value meaning (0: Disable, 1:Enable)
Bit Description
0 Digital Input 0 falling dege
1 Digital Input 1 falling dege
2 Digital Input 2 falling dege
3 Digital Input 3 falling dege
4 Digital Input 0 rising dege
5 Digital Input 1 rising dege
6 Digital Input 2 rising dege
7 Digital Input 3 rising dege
8 CLR/LTC/SD/PCS input 0 Interrupt enable
9 CLR/LTC/SD/PCS input 1 Interrupt enable
10 CLR/LTC/SD/PCS mode (0: falling edge, 1: rising edge)
11~15 Not define (Always set to 0)
To Next Page
Loading...
