FWA-3260 User Manual v02_20160302.docx Copyright 2014 Advantech Co. Ltd. All rights reserved. Page 14
15. The equipment does not work well, or you cannot get it to work according
16. The equipment has been dropped and damaged.
17. The equipment has obvious signs of breakage.
18. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STORAGE
TEMPERATURE MAY GO BEYOND THE RANGE SPECIFIED IN Technical
Specifications. THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT SHOULD
BE IN A CONTROLLED ENVIRONMENT.
19. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY
THE MANUFACTURER, DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURER’S INSTRUCTIONS.
20. The sound pressure level at the operator’s position according to IEC 704-1:1982 is no
more than 70 dB (A).
DISCLAIMER: The set of instructions is given according to IEC704-1. Advantech disclaims all
responsibility for the accuracy of any statements contained herein.
1.1.2 Safety Precautions - Static Electricity
Follow instructions below to protect yourself from harm and the products from damage:
1. Be sure you are at an ESD workstation, or grounded with an ESD strap before opening
the top cover or installing/removing any unit accessible from the outside. Doing so will
discharge any static electricity that might have built up in your body.
2. Don’t touch any components inside the system while the system is on.
3. Disconnect power before making any configuration changes. The sudden rush of power
as you connect a jumper or install a card may damage sensitive electronic components.
4. When unpacking a static-sensitive component from its shipping carton, do not remove
the component's antistatic packing material until you are ready to install the component
in the unit.
5. When transporting any electrical component, first place it in an antistatic container or
packaging.
1.2 Unpacking
Please check the delivery for completeness as you open the carton carefully. If any of the
items listed in Table 1 is missing or damaged, please contact your Advantech
representative.
When opening the box, you will find the FWA-3260 embedded in protective foam and the
accessory box embedded to the foam. Remove the accessory box first and then pull out the
unit including the protective foam using both hands. Now, remove the foam and the plastic
sleeve on the unit.
After unpacking the unit, please check for any visible damage of the unit and contact your
Advantech representative in case of any issue.
Please note that unless agreed otherwise power cords need to be ordered separately. Please
refer to section 2.6 for ordering information.
To Next Page
Loading...
