Advantech FWA-3260 - POST & Boot Menu; Security Setup

FWA-3260 User Manual v02_20160302.docx Copyright 2014 Advantech Co. Ltd. All rights reserved. Page 76
3.2.5 Security Setup
“Administrator Password” allows users to configure the system so that a password after
being installed is required each time the system boots, and/or an attempt is made to enter
the Setup program.
Note:
 If set the “Password Check” is [Setup], then this only limits access to Setup and is only asked for
when entering Setup.
 If set the “Password Check” is [Always], then this is a power on password and must be entered
to boot or enter Setup. In Setup the User will have Administrator rights.
 The password length must be in the following range:
 Minimum length: 3
 Maximum length: 20
3.2.6 POST & Boot Menu
Users can configure the system boot priority settings via the boot page. The default setting
of boot priority of boot option #1 is “UEFI: Built-in EFI Shell”; Users can define the boot
priorities based on the application.