AEMC 5050 - 8 Maintenance; Recharging The Battery

54 Megohmmeter Models 5050/5060
CHAPTER 8
MAINTENANCE
Useonlyfactoryspeciedreplacementparts.AEMC
®
willnotbeheldresponsible
foranyaccident,incident,ormalfunctionfollowingarepairdoneotherthanbyits
servicecenterorbyanapprovedrepaircenter.
8.1 Recharging the Battery
Ifthe symbolisashing,thebatteryneedstoberecharged.
Connect the instrument to the 120VAC power cord via the connector (charging
startsautomatically).
• bAtonthesmalldisplayandCHrG or chAronthemaindisplay,signi-
esfastcharginginprogress.
• bAtonthesmalldisplayandCHrGashingonthemaindisplay,signi-
esslowcharging(startso󰀨withfastcharge,temperatureconditions
permitting).
• bAtonthesmalldisplayandFULLonthemaindisplay,signiesthat
chargingisover.
Iftheinstrumentisstartedupandthebatteryvoltageis>8V,thenthenormaluse
ofthedeviceispermitted.
NOTE: The battery should only be changed by an authorized repair facility recog-
nized by AEMC
®
Instruments.
Changing the battery causes data to be lost from the memory.
PresstheMEM/MRbutton(“OFF”isdisplayed).
ProceedwithatotalclearingofmemoryinSET-UP(see§2.5.7)sotheMEM/MR
functionscanbeusedagain.
w ww . . co m
information@itm.com1.800.561.8187