3.8 Baler options page
3.8.1 Baler options page
Fig. 15
(1) Moisture sensor
(2) Bale scale
(3) Knotter fan
(4) Knotter lubrication
(5) Bale chamber pressure monitor
(6) Bale chamber pressure control
(7) Baler model
(8) Bale dimensions
3.8.2 Set an optional function to ON or OFF
The baler optional function page lets you set the functions of the baler to ON or OFF.
The functions can be set to ON in the baler settings page even if the baler does not have the component. If
you do this, the terminal can show warnings because it cannot sense the component.
The chamber pressure monitoring function cannot be set to OFF if the baler chamber pressure control is set
to ON. If you set the chamber pressure control to ON, the chamber pressure monitoring function will
automatically be set to ON.
Procedure
1. Press the up and down arrows on the keypad to go to the necessary optional function.
Result
The selected optional function shows with a blue square.
2. Press and hold the OK button until the
icon changes to the icon.
3 Operation
42
SimplEbale
To Next Page
Loading...
Need help?
General
