4.1 Sensor adjustments
4.1.1 Adjust the star wheel sensor
DANGER: Dangerous area.
Risk of death or injury.
Before you go into the area between the machine and the implement:
Park the machine on a clean, hard and level area.
Put the parking brake to ON.
If an implement is on the machine, lower the implement to the ground.
Set the ignition to OFF.
Install the wheel chocks.
WARNING: The machine or parts can move without notification.
The parts that move can cause death or injury.
Before you do work on the machine:
If an implement is on the machine, lower the implement to the ground.
Stop the engine.
Remove the ignition key.
Disconnect the PTO shaft.
WARNING: Entanglement with the PTO shaft.
Risk of death or injury.
Make sure that the guards are in position and always operate correctly.
If a guard breaks or is missing, repair or replace it before you use the machine.
CAUTION: Personal Protective Equipment is mandatory.
This procedure can cause injury.
Put on Personal Protective Equipment when you do this procedure.
4 Maintenance
SimplEbale
51
To Next Page
Loading...
Need help?
General
