Purification Solution - Developer's Guide 37
Setting Up and Running a Purification Task
4
Configuring a new task
9 Enter the injection volumes and vial locations for the preparative run into
the table.
You can also use the Location Mappings subpage for this task, or to make any
adjustments.
10 Select each of the subpages, Fraction Collection and Location Mappings, verify
that the parameters are correct, and make any necessary adjustments.
Mark this check box, if:
• you want to review the automatic target identification of individual samples and
eventually correct it by manual target assignment or by changing the target
identification parameters for all samples (in the Task Configuration tab) or for
individual samples (in the Analytical Results tab)
• you want to modify integration parameters, gradient profiles, or target masses for
individual samples
• you want to revise the automatic decision of samples to purify
• you want to adjust fraction collection thresholds or fraction collection conditions for
specific targets
• you are not using an MSD for target identification
Clearing the check box starts the purification step automatically when the target
compounds have been identified.
Parameters that have been changed in the Task Configuration page are applied as global
settings for all samples from a task. They are also applied in all further tasks that you
create if you save and use this task as a template.
To Next Page
Loading...
