140 16900 Series Logic Analysis Systems Installation Guide
A Safety Notices
• Service instructions are for trained service personnel. To avoid
dangerous electric shock, do not perform any service unless qualified to
do so. Do not attempt internal service or adjustment unless another
person, capable of rendering first aid and resuscitation, is present.
• Do not install substitute parts or perform any unauthorized
modification to the instrument.
• Capacitors inside the instrument may retain a charge even if the
instrument is disconnected from its source of supply.
• Do not operate the instrument in the presence of flammable gasses or
fumes. Operation of any electrical instrument in such an environment
constitutes a definite safety hazard.
• Do not use the instrument in a manner not specified by the
manufacturer.
• To optimize your comfort and productivity, it is important that you set
up your work area correctly and use your equipment properly. Refer to
http://www.agilent.com/quality/Working_In_Comfort.pdf for set- up and
use recommendations.
• Position equipment so that it is not difficult to disconnect the power
cord.
To clean the instrument
If the instrument requires cleaning:
1 Remove power from the instrument.
2 Clean the external surfaces of the instrument with a soft cloth
dampened with a mixture of mild detergent and water.
3 Make sure that the instrument is completely dry before reconnecting it
to a power source.
Safety Symbols
Instruction manual symbol: the product is marked with this symbol when
it is necessary for you to refer to the instruction manual in order to
protect against damage to the product.
Hazardous voltage symbol.
To Next Page
Loading...
Need help?
General
