Features and Functions 2
34405A User’s and Service Guide 43
1 To access the Utility Menu, press
2 Press seven times until Error is shown in the
primary display.
3 If there are no errors in the error queue, the secondary
display shows nonE.
If there are one or more errors, Error is shown in the
primary display and nn.Err is shown flashing in the
secondary display (where nn is the total number of errors
in the error queue). For example, if there are three errors
in the queue, 03.Err will flash in the secondary display.
Errors are numbered and stored in the queue in the order
they occurred.
4 If there are errors in the error queue, press to read
the first error. The error number in the queue is shown in
the primary display and the actual error number is shown
in the secondary display.
5 Repeat step 4 for all errors in the error queue
(you can also use to view the previous error).
6 After reading all errors,
press twice to exit the Utility Menu.
7 The error queue is automatically cleared after has
been pressed and the utility menu is exited.
The Beeper
Normally, the multimeter beeps whenever certain conditions
are met (for example, the multimeter beeps when a stable
reading is captured in reading hold mode). The beeper is
factory set to ON, but may be disabled or enabled manually.
Shift
Uti lity
Store
Recall
Store
Recall
Store
Recall
Store
Recall
Edit
Store
Recall
Store
Recall
Edit
34405A users guide.book Page 43 Saturday, September 2, 2006 3:38 PM
To Next Page
Loading...
