Features and Functions 2
34405A User’s and Service Guide 47
Recalling a Stored State
To recall an instrument state:
1 Press , the display Store and Recall annunciators
will begin flashing.
2 Press or until only the Recall annunciator is
flashing.
3 Press again.
4 Press or until the state number you want to
recall is shown flashing in the secondary display. You can
select state 1 through 4 or LASt for the power- down state.
To exit without recalling a state, select ESC.
5 Press to perform the recall (or ESC) operation.
When finished, the secondary display briefly shows donE.
NOTE
To escape the recall operation without recalling a state, select ESC
in step 4 above and press to escape. After escaping, the
secondary display briefly shows - - -
Store
Recall
Store
Recall
Store
Recall
Store
Recall
Store
Recall
Store
Recall
Store
Recall
Store
Recall
NOTE
To escape the recall operation without recalling a state, select ESC
in step 4 above and press to escape. After escaping, the
secondary display briefly shows - - -
Store
Recall
Store
Recall
34405A users guide.book Page 47 Saturday, September 2, 2006 3:38 PM
To Next Page
Loading...
