52 34410A/11A User’s Guide
2 Features and Functions
To select any stored state (0 through 4) as the power–on default state,
enter the STORE/RECALL level of the UTILITY MENU. Press as needed to
select PWR–ON, and press . PWR–ON–AUTO will be displayed. Select ON
(OFF is the default), and press . PWR–ON STATE will be displayed,
along with any stored states, on the second display line. along with any
stored states, on the second display line. Press as needed to select
a stored state, and press . CHANGE SAVED will be briefly displayed on
the secondary display line.
• Remote Interface Operation: Refer to the MEMory command subsystem in
the Agilent 34410A/34411A Programmer’s Reference for complete
description and syntax for the commands which store, recall and name
multimeter storage states.
Multimeter Reset
A fast system reset feature is provided. This function resets all multimeter
settings to their factory settings, except if the power–on state has been
manually set to a stored state (see explanation on page 52). The result is
the same as cycling power to the unit with the front panel Power button
(except for the Error Queue, which is not cleared with a fast system
reset), but does so several seconds faster.
• Refer to “Power- On State” on page 49 for a complete listing of the
settings affected by a (front panel or remote interface) reset command.
• Front Panel Operation: To reset the multimeter, press .
RESET DMM will be displayed, along with the options NO (default) and YES.
Select YES to enable the reset operation or NO to cancel it.
• Remote Interface Operation: The following commands resets the multimeter
to the instrument preset state:
SYSTem:PRESet
*RST
Refer to the Agilent 34410A/34411A Programmer’s Reference for
complete description and syntax for this command.
To Next Page
Loading...
