General Troubleshooting 2
Troubleshooting and Maintenance Manual 41
• MS electronics are not working correctly
* This will cause an error message.
GC/MS interface will not heat up
• Incorrect setpoint(s)
• Setpoint entered in wrong heated zone
• GC/MS interface has not had enough time to reach temperature setpoint
• GC is off
• GC experienced a fault and needs to be reset*
• GC/MS interface heater/sensor cable is not connected*
• GC/MS heater failed (burned out)*
• GC/MS sensor failed*
• GC electronics are not working correctly*
* This will cause a GC error message. GC error messages are described in
the documentation supplied with your GC.
To Next Page
Loading...
