Agilent Technologies 7010 Series User Manual

7000/7010 Series TQ GC/MS Operating Manual 147
7 General Maintenance
Before Starting 148
Maintaining the Vacuum System 153
Maintaining the Analyzer 154
To Open the Front Analyzer Chamber 156
To Remove the EI HES 159
To Connect or Disconnect Wiring to the EI HES 161
To Remove the EI XTR Source 162
To Connect or Disconnect Wiring to the EI XTR Source 164
To Disassemble the EI HES 165
To Disassemble the EI XTR Source 168
To Clean the EI HES 171
To Clean the EI XTR Source 174
To Assemble the EI HES 177
To Assemble the EI XTR Source 182
To Install the EI HES 185
To Install the EI XTR Source 187
To Remove a Filament from the EI XTR Source 189
To Install a Filament on the EI XTR Source 191
To Remove the EI HES Filaments 192
To Install the EI HES Filaments 194
To Close the Front Analyzer Chamber 195
To Remove Left Rear Cover 196
To Open the Rear Analyzer Chamber 198
To Replace the EM Horn 201
To Close the Rear Analyzer Chamber 203

Agilent Technologies 7010 Series Specifications

General

Brand	Agilent Technologies
Model	7010 Series
Category	Laboratory Equipment
Language	English