Agilent Technologies 7010 Series User Manual

7000/7010 Series TQ GC/MS Operating Manual 205
8 CI Maintenance
General Information 206
To Switch from an EI XTR Source to the CI Source 207
To Remove the EI HES Radiator 208
To Connect or Disconnect EI HES Radiator Wiring 210
To Install the 7010 Series CI Source 211
To Switch from the CI Source to the EI HES 213
To Install the EI HES Radiator 214
To Switch from the CI Source to the EI XTR Source 216
To Connect or Disconnect 7010 Series CI Source Wiring 217
To Connect or Disconnect 7000 Series CI Source Wiring 218
To Switch from the CI Source to an EI XTR Source 219
To Remove the 7000 Series CI Source 220
To Switch from the EI HES to the CI Source 222
To Install the CI/EI XTR Source Radiator 223
To Switch from the CI Source to the EI HES 225
To Install a CI Source Filament 226
To Remove the CI Source Radiator from the 7010 Series TQ 227
To Disassemble the CI Source 229
To Clean the CI Source 232
To Assemble the CI Source 235
To Remove the CI Source Filament 238
To Install a CI Source Filament 240
This chapter describes maintenance procedures and requirements that are unique
to 7000/7010 Series MS equipped with the CI hardware.
If you are using the Agilent Intuvo 9000 Gas Chromatograph with your MS,
Chemical Ionization (CI) is not currently supported.

Agilent Technologies 7010 Series Specifications

General

Brand	Agilent Technologies
Model	7010 Series
Category	Laboratory Equipment
Language	English