1Introduction
Intended Use
28 7000/7010 Series TQ GC/MS Operating Manual
Intended Use
Agilent products must only be used in the manner described in the Agilent
product user guides. Any other use may result in damage to the product or
personal injury. Agilent is not responsible for any damages caused, in whole or in
part, by improper use of the products, unauthorized alterations, adjustments or
modifications to the products, failure to comply with procedures in Agilent
product user guides, or use of the products in violation of applicable laws, rules
or regulations.
Cleaning/Recycling the Product
To clean the unit, disconnect the power and wipe down with a damp, lint-free
cloth. For recycling, contact your local Agilent sales office.
Accidental Liquid Spill
In case of an accidental liquid spill, first turn off the MS and remove the power
cord from the buildings electrical power supply. Then call your local Agilent
service representative for assistance.
Only Agilent trained technicians should service the electrical components inside
an MS.
Moving or Storing the MS
The best way to keep your MS functioning properly is to keep it pumped down
and hot, with carrier gas flow. If you plan to move or store your MS, a few
additional precautions are required. The MS must remain upright at all times; this
requires special caution when moving. The MS should not be left vented to
atmosphere for long periods. (See “Moving or Storing the MS“ in the 7000/7010
Series TQ GC/MS Troubleshooting and Maintenance Manual.)
To Next Page
Loading...
Need help?
General
