Agilent Technologies 7010 Series - Operating the MS from the Data System

5 Operating in EI Mode
Operating the MS from the Data System
96 7000/7010 Series TQ GC/MS Operating Manual
Operating the MS from the Data System
The Agilent MassHunter GC/MS Acquisition software performs tasks such as
pumping down, monitoring pressures, setting temperatures, tuning, and
preparing to vent. These tasks are described in this chapter. Additional
information is described in the manuals and online help supplied with the
MassHunter GC/MS Acquisition software.
Your 7000 TQ operates in EI mode using the EI XTR Ion Source Assembly, and
your 7010 TQ operates in EI mode using the EI HES Source Assembly, which
provides higher sensitivity when ionizing the sample.
CAUTION
The software and firmware are revised periodically. If the steps in these
procedures do not match your MassHunter Workstation software, refer to the
manuals and online help supplied with the software for more information.