Methods 6
Operation 51
Data system methods
If using an Agilent data system, you will primarily use the
data system methods, rather than the methods stored locally
in the HS. Data system methods save parameters for all
associated instruments and devices, such as the GC and HS,
plus all data analysis and reporting settings.
When running a sequence, the data system will download
the setpoints to the HS as needed. HS data system method
parameters appear on the HS display as a HOST method. The
HS does not permanently store HOST methods. HOST
methods only remain until overwritten or until the HS is
turned off.
Wake Use the Wake method to load settings after the sleep
period ends, for example, to warm the vial oven or
increase gas flows. If desired, the wake method can be
simply the last analytical HS method run. The wake
method is editable. To schedule the instrument to load
the wake method at a given time of day, see the
Advanced Operation Guide.
Method Comments
To Next Page
Loading...
Need help?
General
