Sequences 7
Operation 69
To Create a Sequence
To create a new sequence:
1 Press [Seq].
2 Select the method for the first vial range.
a Press [Mode/Type].
b Scroll to the desired method.
c Pres [Enter] to select this method.
3 Enter the range of vial to prepare with this method.
• For a simple range, for example vials 1 through 5,
press [1][–][5][Enter].
• For a single vial, enter the vial twice, for example,
[6][–][6][Enter].
4 Enter the number of injections per vial, then press [Enter].
The sequence is created. You can now store the sequence
(see “To Save (Store) a Sequence”), run it (see “To Run a
Series (Sequence) of Samples”), or continue to add
additional lines as described below.
5 To enter another range of vials, press [Insert/Append].
When prompted, select where to add the new sequence
line then press [Enter]:
• Append to sequence: add the new line to the end of the
sequence
• Insert into sequence: add the new line before the current
sequence line
6 Enter the method, vial range, and number of injections
per vial for the new line.
7 Repeat step 5 and step 6 as needed.
You can now store the sequence (see “To Save (Store) a
Sequence”) or run it (see “To Run a Series (Sequence) of
Samples”).
To Next Page
Loading...
