Methods 6
Operation 55
d
Scroll to Loop fill mode, then press [Mode/Type] to display
the selections for the sample loop fill mode. Select the
desired loop fill mode.
e Enter any sample loop fill mode parameters, pressing
[Enter] after each.
f Scroll to Vent after extraction. Press [On/Yes] to vent the
sample loop after the last each extraction, or [Off/No]
to leave the loop as- is.
g Scroll to Vial size. Press [Mode/Type] to select the vial
size from a list, then press [Enter].
h Scroll to Shaking. Press [On/Yes] to enable, then press
[Mode/Type] to select the level of shaking desired. Press
[Off/No] to disable shaking for this method.
Vial settings are complete.
4 Press [Carrier]. If not using an optional EPC carrier gas
module, these settings are disabled and the HS uses GC
carrier gas control. If using the optional EPC carrier gas
module, you can set parameters as defined by the
configured carrier gas control mode.
Set carrier gas parameters using the same process as the
other method parameters.
Carrier gas settings are described in the Advanced
Operation Guide.
5 Basic method parameters are complete. Save the method.
(See “To Save (Store) a Method”.)
In addition, the Adv Function key provides access to other
method parameters, including multiple headspace extraction
modes and functions useful during method development.
See the Advanced Operation Guide for more information.
To Next Page
Loading...
Need help?
General
