42
Getting Started
Setting Up a Burst Signal
Programming
example
If you want to include this burst signal in your GP-IB program use the
following command lines. The comment lines starting with a # are not
required.
# Reset the instrument to start from a defined, default status.
*RST
# Switch off the automatic display update to increase programming
# speed.
:DISPlay OFF
# Set the instrument to burst mode by selecting a burst count
# of 2. Choose double pulses. Select triggered mode by selecting
# PLL as the trigger source and set the burst repetition to 2 µs.
:TRIGger:COUNt 2 # Set Burst mode with burst count of 2
:ARM:SOURce INT2 # Set Triggered mode with PLL as
# trigger source
:ARM:PERiod 2US # Set burst repetition of 2 µs
:PULSe:DOUBle ON # second channel generates double pulses
# per period
# Set the double pulse delay to 200 ns and the width to 100 ns.
:PULSe:PERiod 500NS
:PULSe:WIDTh 100NS
:PULSe:DOUBle:DELay 200NS
# Set the output amplitude to 2 Volts and the offset to
# 0.0 Volts.
:VOLTage 2V
# Enable the output.
:OUTPut ON
To Next Page
Loading...
Need help?
General
