DFB Laser Sources Error Messages
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition 413
error message E10060: Laser <a> control failed (b, c, d, e)
description Checks the laser current source
test value a laser number
b measured current at low per and normal current source
setting
c measured current at low power and high current source
setting
d measured current at high power and normal current
source setting
e measured current at high power and high current source
setting
action Please return the unit to your local service center for repair
error message E10080: Laser <a> control for safety test failed
description To test the current safety comparator the laser current needs to
be set to two different values
test value a laser number
action Please return the unit to your local service center for repair
error message E10081: Safety comparator <a> test failed (b, c)
description Checks whether laser current safety comparator includes at the
right conditions a safety interrupt at the CPU
test value a laser number
b shows whether the interrupt flag was raised when the
current was lower than the limit
c shows whether the interrupt flag was raised when the
current was higher than the limit
action Please return the unit to your local service center for repair
To Next Page
Loading...
