EasyManua.ls Logo

Agilent Technologies Agilent 3499A

Agilent Technologies Agilent 3499A
357 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
128
Chapter 5 Remote Interface Reference
Switch Commands
5
[ROUTe:]
CLOSe:STATe?
This query returns a comma-delineated list of the closed channel relays
for all relays on all installed plug-in modules. The returned values will
be in the form snn, where s is the slot number and nn is the channel
number. The returned values indicate the programmed state of the relay.
This query does not physically monitor a relay and cannot report a failed
relay.
[ROUTe:]
OPEN <channel_list>|ALL
OPEN? <channel_list>
This command opens all the switching channels specified in the
channel_list
.
The channel_list has the form @snn, where s is the slot
number and nn is the channel number. See the CLOSe command
description for a description of channel_list.
The OPEN? query returns a “1” for open channels and a “0” for a closed
channel. If you specify a list of channels, the query returns a comma
separated list of 0’s and 1’s, in the same order as the channel_list. The
returned values indicate the programmed state of the relay. This query
does not physically monitor a relay and cannot report a failed relay.

Table of Contents