17
Chapter 1 Quick Start
To Install a Module in the 3499A/B/C
4
1
To Install a Module in the 3499A/B/C
The plug-in modules you ordered were not installed in the mainframe.
The figure on page 18 shows how to install a plug-in module into the
3499B mainframe. Other mainframes use similar procedures.
WARNING Disconnect the power cord from the rear panel of the mainframe prior to
installing or removing any modules.
Caution Use anti-static procedures when configuring, installing or removing any
plug-in modules. To prevent contamination to the modules that could
degrade performance, handle the modules by the side edges or shields
only. Do not touch the board surfaces or components.
Each plug-in module may have terminal block(s) and/or the cables for
wiring to external circuits. These terminations are also shipped
separately.
For more details about terminal blocks, cables, and connections, see
“Terminals and Connections Information” on page 275.
Module Removal
To remove a plug-in module from the Agilent 3499A/B/C mainframe,
reverse the procedures shown on page 18.
To Next Page
Loading...
Need help?
General