Agilent Technologies Agilent 3499A

To Next Page

To Previous Page

116

Chapter 5 Remote Interface Reference

3499A/B/C SCPI Alphabetical Reference

Command Summary

3499A/B/C SCPI Alphabetical Reference

Note Default command parameters are shown in bold.

ABORt

Abort a scan in progress regardless of the trigger source. See page 138.

ARM

Set trigger source in ARM layer. See page 134.

:SOURce?

Query trigger source in ARM layer. See page 134.

:COUNt <number>[MIN|MAX]

Set counter in ARM layer. See page 134.

:COUNt? [MIN|MAX]

Query counter in ARM layer. See page 134.

:TIMer <seconds>|MIN|MAX

Set timer for sweep-to-sweep (sweeping). See page 135.

:TIMer?

Query timer in arm layer. See page 135.

CONFigure

:EXTernal[:TRIGger]:SOURce <number>

Select the trigger source. See page 137.

:EXTernal[:TRIGger]:SOURce?

Query the trigger source. See page 137.

:EXTernal[:TRIGger][:OUTPut] <0|1|OFF|ON>

Turn off/on the external trigger output. See page 137.

:EXTernal[:TRIGger][:OUTPut]?

Query state of external trigger output. See page 137.